critical solution temperature
英 [ˈkrɪtɪkl səˈluːʃn ˈtemprətʃə(r)]
美 [ˈkrɪtɪkl səˈluːʃn ˈtemprətʃər]
临界共溶温度
双语例句
- Thermosensitive Polymers with Upper Critical Solution Temperature high performance/ cost ratio.
具有高临界相转变温度的热敏性高分子材料性能价格比高。 - A new method for preparation of polysulfone hollow fiber ultrafiltration membranes using the lower critical solution temperature ( LCST) systems has been developed.
本文探索采用一种新颖的制膜体系和制膜方法制备聚砜中空纤维超滤膜。 - Investigation of Preparation of Polysulfone Hollow Fiber Ultrafiltration Membranes with Lower Critical Solution Temperature Systems
下临界共溶温度体系制备聚砜中空纤维超滤膜的研究 - Study on critical solution temperature of water-phenol by means of cloud point
浊点法研究水-苯酚系统的临界溶解温度 - UV analysis showed that the low critical solution temperature ( LCST) of P ( CS-g-AA/ PNIPAm) is higher than that of poly ( N-isopropylamide) in aqueous solution.
紫外光谱分析结果表明，P（CS-g-AA/PNIPAm）水溶液比异丙基丙烯酰胺均聚物的最低临界溶解温度（LCST）略高。 - The separation of PNIP in the assay process was achieved by precipitation of the immuno-complex above its critical solution temperature. The amount of MT was determined by measuring the initial rate of the oxidation of 4-aminoantipyrine by H2O2 catalyzed by HRP-immuno-complex precipitated.
根据临界析相温度以上免疫复合物沉淀的特性进行分离，根据沉淀相HRP催化H2O2氧化4-氨基安替比林显色反应的初速度可确定样品中MT的浓度。 - Thermosensitive polymers with upper critical solution temperature ( UCST) are introduced, which exhibit a high critical phase transition temperature. Their phase transition and the relative factors are discussed.
介绍了一类具有高临界相转变温度（UCST）的热敏性高分子材料，并对其相转变机理、热敏性影响因素及表征方法做了讨论。 - The hydrogels show a LCST ( lower critical solution temperature) around 30 ℃.
该水凝胶的最低临界溶液温度（LCST）为30℃左右。 - It was found that POM/ Novolak blends showed a lower critical solution temperature in their cloud point curve and the melting point decreasing by DSC test.
浊点法研究结果表明，POM/Novolak共混物存在一个低位临界相转变温度。 - A new high strength metastable beta titanium alloy ( Ti-B20) was designed according as the principle of 'near critical molybdenum equivalent and multicomponent strengthening'. The effect of solution treatment on aging response of the new alloy including room temperature tensile properties and microstructures were investigated.
根据近临界钼当量和多元强化原则设计了一种新型亚稳β钛合金（Ti-B20），以室温拉伸性能和显微组织为主要考察内容研究了固溶处理对这种新合金时效响应的影响。 - The Lower Critical Solution Temperature ( LCST) of the copolymers was determined by fluorescence probe and turbidity measurement method.
利用浊度法和荧光探针法测定了共聚物的最低临界溶液温度（LCST）。 - Thermally light scattering hydrogels were prepared by incorporating polyether with lower critical solution temperature ( LCST) properties in polyvinyl alcohol matrices crosslinked by glutaraldehyde.
以戊二醛交联的聚乙烯醇水凝胶为基体，掺杂具有临界溶解温度（LCST）特性的水溶性聚醚，制得了具有调光功能的热致散射聚醚/聚乙烯醇水凝胶。 - The results show that ( 1) the system possesses an upper critical solution temperature ( UCST) behavior and its phase separation is completely reversible in all investigated blends;
结果表明，PPE/TAIC体系具有最高上临界温度行为，在所研究的范围内，相分离是完全可逆的。 - It is shown that there are two lower critical solution temperature ( LCST) ATP systems in two regions in which SDS or CTAB is excessive. The ATP regions were enlarged with the increasing temperature.
结果表明，该系统可以在SDS或CTAB过量的两个区域形成双水相，属于最低临界共溶温度（LCST）类型，温度升高导致双水相区域扩大。 - PPE/ EP system exhibits an upper critical solution temperature ( UCST) behavior. It discussed in detail the influencing effects of the molecular weight and the use amount of PPE, compatilizer and the modified PPE on the compatibility of PPE/ EP system.
PPE/EP是具有最高上临界温度的体系，详细讨论了PPE的分子量和用量、相容剂以及改性PPE对PPE/EP体系相容性的影响。 - The lower critical solution temperature ( LCST) was measured by viscometry.
采用黏度法测定了聚合物的低温溶解温度（lowercriticalsolutiontemperature，LCST）； - By use of the basic formula of chemical thermodynamics and according to the stabilizing conditions of binary solutions at critical points, two equations of critical state which can be used to make certain about the form of binary solution, critical temperature and critical points have been derived.
利用化学热力学的基本公式，根据二元溶液临界态的稳定条件，通过数学推导，得到了两个可以用来确定二元溶液临界温度及临界点组成的临界态方程。 - Temperature-controlled UV-Vis, microscopy and 1H NMR are adopted to investigate its Lower Critical Solution Temperature ( LCST) phase transition.
采用变温紫外光谱、光学显微镜和核磁等手段对其最低临界溶解温度（LCST）相转变进行了详细表征。 - LCST ( Lower Critical Solution Temperature) is a very important property of thermally sensitive polymers.
温敏聚合物有一个主要的特性&最低临界溶解温度（lowercriticalsolutiontemperature）。 - The critical micelle concentrations of SDS in aqueous solution at different temperature and urea concentration were obtained by conductance and the thermodynamic parameters dependence of temperature and urea concentration for the formation of SDS micelle were also obtained by the thermodynamics of micellar formation. 2.
通过水溶液中SDS电导的测定，得到不同温度不同尿素浓度下SDS水溶液的临界胶束浓度，根据胶束形成的热力学特性，得到SDS胶束形成的热力学常数与温度、尿素浓度之间的关系。 - The study showed that the introduction of MWNT further improved the mechanical properties and conductivity, and also had a certain effects on the low critical solution temperature ( LCST) of the gel.
研究表明，MWNT的引入进一步提高了凝胶的力学性能和导电性，对凝胶的低临界溶解温度（LCST）也有一定的影响。 - Rheological properties of aqueous solution and cement paste which modified with CE were discussed under different temperature and pH. At the same time, the lower critical solution temperature and isoelectric point of CE were obtained.
探讨了不同温度和pH值时CE在水溶液和水泥浆体中的流变特性，确立了CE的低临界溶解温度和等电点。